Antennas Hold Up Through Storm Conditions

-

WX Warning of severe storms!


The UK continues to get battered with gale force winds, snow and lots of heavy rain storms. Here in Baildon, West Yorkshire my Ham radio antennas are holding up well  despite the bad WX conditions. Earlier I had to recover my daughters play house which had been dismantled and blown away, fortunately it will be ok and should easily be reassembled. Our dustbins have also wandered off somewhere down the garden spitting rubbish out along the way, which will be not so fun to collect in the morning.
All things said and done I can't complain too much as I am well used to bad weather due to living at altitude up on the windy Yorkshire Pennine mountains.
Hopefully the storms will ease up in the early hours of tomorrow as predicted and the antennas will remain undamaged.

Recent Radioactivity

 I have been enjoying some good openings on 20m whilst mobile especially in the mornings and during the past three weeks I have made qso's into the US, Tasmania, Australia, Lebanon, Algeria and lots of Europe. My FT-857 & Maldol antenna is performing well for me as a mobile station and I have had some great radio reports.

I have also been pleasantly surprised with the recent homebrew 20m delta loop that I installed and my dining room operation on my old FT-890. I have worked a number of stations using this second setup here at my qth with great results both DX and short skip. The delta loop tunes up well with an old Nevada TM1000 tuner, I have been able to make qso's on other bands that I would not of expected too, again with good results. I have been using a paper log to record my progress with the dining room setup which I may share more details in a later post. Surprisingly,  I can tune the vertically polarised delta loop on 40m, 17m, 15m 12m & 10m as well as its resonant band 20m. I have been enjoying using it so much I must confess to neglecting my main shack set up and antennas.  I am sure that I will soon get back to my FT-1000/847 and comfy armchair just as soon as the novelty of the loop and FT-890 wear off h.i.

 Hope to hear some of you somewhere on the bands soon providing my antennas hold up, next week I am on holiday from work and should be active on HF and the Satellite bands. 73!

Comments

Post a Comment

Popular posts from this blog

New DX Contact 0n 12 Meters

-
Image
Today I managed a nice QSO with Tom ZD7X who is located at St. Helena which is quite a distance away from my location. I managed to work Tom ZD7X with a 5/9 report operating my FT-767GX with my home brew 20m delta loop assisted with the MFJ-969 to tune the antenna with 50 watts on 12 meters. 12M is rarely open and I have only had a few QSOs on this band so I guess the new Cycle has begun at last! Good DX de 2E0HTS 73
Read more

Full Size Delta Loop for 20M

-
Image
I came across a simple delta loop design courtesy of dxzone found on the net some time ago and have been planning to give it a go for a while. This weekend I had a couple of hours spare, so I decided to give it a go using some 2mm multi strand wire cable, a dipole centre and a mixture of 75 ohm and 50 ohm coaxial cable. The delta loop is supposed to be resonant on 20 meters but I found it to be a little high so at present I am tuning the Loop with my mfj-969 which copes extremely well. The resonant frequency is 13.2 MHz at the moment so the next chance I get, I shall shorten the overall length making sure that each of the three sides are still equal in length, and hopefully adjusting the antenna for maximum performance ATU free for 14.2 MHz. I believe the miscalculation in the resonant length is probably down to the fact that my wire is covered in the plastic sleeving from the manufacturer which always effects the swr as I have noticed in past experiments with dipoles you always get sl
Read more

Homebrew 40/80 Trap Dipole Design

-
Image
This Antenna design was one that I used about 4 years ago, it worked exceptionally well on 80m and 40m. The size of the antenna makes a Half wave length on 80 meters, and with the traps a half wave on 40m with a SWR (standing wave ratio) of 1:1-1.5 across both bands. It worked well also on 20m with the use of an A.T.U (antenna tuning unit). I made my version of this antenna using 3mm multi strand copper cable which I left covered by the PVC insulation. The traps can either be home brewed using some 40mm diameter plastic drain pipe and winding wire around the pipe approximately 10 turns, then connected in line after the 10 metre lengths. Or the alternative is to purchase some commercially made 7.1 MHz traps, and fit them in line the same way. The antenna can be fed with 50 ohm coax with a home brew balan or again a commercially purchased balan. The wire lengths of the dipole are 2x 10 metres and 2x 6.7 metres as shown on the diagram above. This antenna can be mounted quite low to the gr
Read more